10.3 inch LCD UV Resin SLA 3D Printer Compatible ACF Release Film Roll for Elegoo Saturn 2/3 Ultra and Anycubic Photon M5S/M7 Pro

Description

10.3 inch LCD UV Resin SLA 3D Printer Compatible ACF Release Film Roll for Elegoo Saturn 2/3 Ultra and Anycubic Photon M5S/M7 Pro

10-10.3 inch SLA LCD 3D Printer ACF Release Film

2/5pcs ACF Release Film for Elegoo Saturn 2 3 Ultra, ANYCUBIC Photon M5S, M5S PRO, M7 Pro High Speed ACF Release Film sheet Roll

Compatibility

290mm(Length)*210mm(Width)*0.3mm(Thickness)
Suitable for 10-10.3 inch LCD UV Resin SLA 3D Printer

Compatible with
Elegoo Saturn 3 Ultra 12K
Elegoo Saturn 3 12K
Elegoo Saturn 2 8K
Anycubic Photon M5
Anycubic Photon M5s
Anycubic Photon M5s Pro
Anycubic Photon M7
Creality Halot-Mage
Creality Halot-Mage Pro
Creality Halot-Mage S
CrealityCT-005 Pro 2023
Phrozen Sonic Mighty Revo
Phrozen Sonic Mighty 4K

Other SLA 3D printer with 10-10.3 inch LCD

Other Models

Please contact with us if your 3D Printer is not included in above list, or you can measure the size of your resin vat/tank, be sure the size of the release film is slightly larger than the size of the resin tank, then it can also fit your 3D printer.

Higher Speed and Lower Release Force

ACF film is more flexible and has lower release force compared to FEP and NFEP film. This just makes prints better, since it won’t stick to the film thus avoiding support’s breakage, so it also means a higher success rate and support high speed printing.

High Quality Material

Our ACF film is made of high quality material and with 0.3mm thickness and bettter flexibility, someone’s thickness is not enough and which may cause vertical lines or split-level during 3D printing.

Tips for How to Reduce Adhesion

Please add supports evenly, because no matter what kind of release film it is, it has a certain adhesion, so every slight shaking when pulling up and down will cause the model to be uneven or mis-layered, so add supports evenly can reduce the shaking of the model and obtain a more perfect print.

Ideal Replacement

It is a good replacement for your 3D printer release film.

One side of the ACF is smooth and covered by a blue protective film, which should be removed before use. This smooth side should face resin during use. The frosted back side faces the LCD screen. When installing and removing the blue protective film, please lay the ACF release film flat on a clean table to avoid creases on the surface of the release film.

Package

Protectived by blue film. wrapped and packed in hard paper tube, ensure arrived in good condition.

Cleaning

After each printing failure, the impurities in the material tank must be cleaned in time, otherwise it may cause another printing failure or even damage the release film or LCD screen.

Tips for Cleaning: Use the printer’s built-in cleaning function, or manually expose the bottom layer for 10-30 seconds, then lift and remove the entire cured bottom layer to remove impurities more efficiently.

Soft Scraper

Our this professional scraper is made of soft and smooth material, easy to scrape off residual resin without damaging the film. DO NOT USE hard plastic scraper, it will damage the film even LCD screen. If you need it, please find it in our store and order together.

Works Display